Hand Pump from Hatsan Arms with vent. Embedded in the handle, moisture absorber (protects pump and airgun from moisture) and particle filter (protects from dust & dirt). For filling air tanks of PCP airguns. Maximum 200 bar (2900 psi) fill pressure.
Operation - use the hand pump in areas with low humidity. Do not pump for more than 5 minutes at a time (about 50 cycles). After each pumping, use a 15-minute break for the pump to cool down. To remove excess hot air, loosen the pressure valve located at the bottom of the device. This action also allows you to remove excess moisture inside the pump. The hand pump pumps in both directions (when raising as well as lowering the handle).
Grip - ergonomic handle made of textured soft rubber in black.
Particle filter - inside the grip there is a particle filter made of copper pellets through which air is drawn. Placing the air intake at a height of about 65 cm allows the intake of air with lower humidity, and the built-in particle filter retains the remaining moisture from the air, protecting the PCP air tube and the air gun. Inside the grip there is also a desiccant cartridge which, in addition, removes moisture from the drawn air.
Hose - the unscrewable high-pressure hose with a length of about 50 cm allows you to fill the air tube of the air gun yourself. Before pumping, you need to screw into the hose of the pump the tip for shunting air into the air bottle included in the kit of each Hatsan PCP air guns.
Safety - the device is equipped with a precise pressure gauge graduated from 0 to 250 bar and a bleeder valve allowing you to fill the air tank as well as safely disconnect the filled cartridge from the hand pump. You should always loosen the pressure valve before disconnecting the pump from the cartridge. Failure to perform the loosening procedure may result in damage to the seals. The pump's stable, adjustable base makes it easy to use the pump safely while pumping.
Important! Recommended maximum working pressure of the hand pump 200 bar. Recommended maximum working pressure of the PCP air bottle 200 bar.
Developed by: the Sharg® company
